First gauge the size of the wall. Of course, I know what things to expect before construction. Secondly, take away the original paint, wallpaper and other objects on the wall. Gauge the height from the very best of the wall structure to the baseboard and cut the wallpaper. Do not use the wall height of the flower wall to cut about 10 cm, and use it for higher and lower trimming. Brush the bottom film and evenly brush the bottom film on the wall structure with a moderate thickness. In order to ensure a company paste, the back of the wallpaper and the wall should be glued, and the glue should be evenly applied.

Step 1: Measuring
First gauge the size of the wall. Of course, I know what things to expect before construction.
Step 2 2: Remove the wall skin
Remove the original paint, wallpaper and other objects on the wall. If there are cracks or potholes on the wall, use gypsum powder to fill these places, and put a bandage on the smooth; if there is a sand wall or a partition wall structure, it should be covered with glass cloth or an excellent cloth; some low quality partition walls Or to obtain the insulation effect of the outer wall structure, you should be full of gypsum board.
Step 3 3: Crop wallpaper
Measure the height from the top of the wall to the baseboard and cut the wallpaper. Do not really adjust the height of the wall based on the elevation of the wall structure by about 10 centimeters for the higher and lower trimming; for the flower wallpaper, the symmetry of the pattern needs to be considered, it requirements a lot more than 10 cm, and the flower ought to be taken from the top, and the program is lower and numbered. To be able to paste in order. Furthermore, the cut wallpaper generally must be immersed in drinking water for 10 minutes before it can be glued.

Step 4 4: Brush foundation film scraping
Brush the bottom film, evenly brush the base film on the wall surface, the thickness is average; putty putty, sanding. Make two batches of putty on the wall. After the putty is definitely dried, sand the wall with sandpaper, rub the uneven particles to make the wall simple and flat; evenly paint the wall surface area (cover color) with the base film, no need to be as well thick. This prevents the wall from 3D Wallcoverings absorbing the wallpaper glue, producing the wallpaper stick to the wall surface and producing the wall surface flatter.
Step 5: Brush the glue
To be able to ensure a company paste, the trunk of the wallpaper and the wall should be glued. The glue should be evenly coated. It should not be wrapped or piled up to avoid soiling. Glue the wall, the width should be 30 mm wider than the wallpaper. After the back again of the wallpaper can be glued, the glue is placed on the facial skin for 5 minutes, that may prevent the rubber surface area from blow drying quickly and isn’t easily contaminated.

Step 6: Paste
The principle is to first vertical and then horizontal, first along, first high and then low. When attaching the initial sheet of paper, search for the reference collection at the corner of the corner, carefully flatten it throughout, from the center to the sides, and scrape it with a scraper to make the wallpaper and the wall stay. When attaching the next wallpaper, overlap the overlap with the initial sheet of paper by 20 mm, divide the overlapping part with a wallpaper knife, take away the remaining portion, and scrape with a squeegee. It should be mentioned that the glue that’s squeezed out of the wallpaper should be wiped clean with a wet towel in time in order to avoid yellowing of the wallpaper.