Many owners have no idea how to deal with the aged wallpaper on the wall when replacing the wallpaper; in the event that you continue to paste brand-new wallpaper on the older wallpaper, the old and older wallpapers may fall off the beaten track together due to the dampness of the adhesive. The ultimate way to do that is certainly to strip the aged wallpaper so that the wall covering sticks to the wall structure more firmly.
Here are some ways to uncover old wallpapers.
Peelable wallpaper
1. Pick an inconspicuous corner near the top of the wall and use the suggestion of the utility knife to get the wallpaper.
2. Try to be near to the wall structure, pinch the part of the wallpaper, and try to take it off from the wall structure. Strip the wallpaper in your path, which makes it easier to take away the wallpaper. If it’s a peelable wallpaper, the wallpaper will detach from the wall structure as long as you are strenuous and moderate.
Cut and infiltrate
1. Use a utility knife, razor blade or wallpaper Pure paper Wallcoverings scraper to slice the outdated wallpaper horizontally, each slit is approximately 20 or 25 cm apart.
2. Apply water or wallpaper remover and wait a few minutes for the wallpaper to completely saturate.
3. Repeat the same process on the next wallpaper strip, then go back to the first strip and re-wet it throughout with the formulation.
4. Begin stripping the wallpaper with a multi-purpose edging knife with a 8.9 cm wide, movable blade. Beginning with a cut horizontal wallet, the blade is usually placed under its upper edge and the blade reaches an angle of 30 degrees to the horizontal, and the sliding blade scrapes the wetted wallpaper. A wallpaper this is the same width as the squeegee will fall off the blade and roll onto the squeegee as the blade pushes down.
5. Continue steadily to push down before wallpaper can no longer be peeled off. If the scraped wallpaper tape breaks, re-infiltrate this region and begin to scrape another tape.
Steam method
It is not easy to peel from the lime aged wallpaper. You can rent a steam engine, but you still need to use a wide-blade putty knife to scrape the majority of the wallpaper.
1. After the water is scorching, press the steam plate on the wall structure until the wallpaper on the advantage of the steam plate becomes dark due to moisture. Start with a strip of paper and steadily peel off the wallpaper from top to bottom.
2. After steaming half of the paper strip, make use of a nail or a computer program knife to draw up the corner of the very best of the wallpaper and tear off the wallpaper. If the wallpaper can’t be removed, it could be scraped off with a wall structure scraper. You may want to steam the same area twice or 3 x to loosen the adhesive for the much longer a few months of the wallpaper.
For waterproof coatings, cleaning the wall paper glue with alcohol will not cause much harm to the wall. Instead, the volatilization of alcoholic beverages can minimize the harm to the wall. But one thing to notice is that the concentration of alcohol shouldn’t be too high. In any other case, the volatility can be too big, and it is easy to make the white wall turn yellow or black. This is an extremely bad phenomenon.
This method uses physical friction. But because salt is usually a white crystal, you don’t need to worry about the unusual color that the friction brings to the wall structure. Along the way of rubbing, you may use white gauze or cloth that can hold salt, pack a little packet of salt, softly rub, gradually you will see that the glue remaining on the wall structure paper is gradually disappearing, and stuck in On the top of the fabric, you merely need to rub and stop to eliminate the glue from the gauze. The next phase is not to be said.