Peelable wallpaper
1. Select an inconspicuous corner at the top of the wall and use the suggestion of the utility knife to pick up the wallpaper.
2. Try to be near to the wall, pinch the part of the wallpaper, and make an effort to take it off from the wall structure. Strip the wallpaper in your path, which makes it easier to take away the wallpaper. If it’s a peelable wallpaper, the wallpaper will detach from the wall as long as you are strenuous and moderate.

Cut and infiltrate
1. Cut the aged wallpaper horizontally with a utility knife, razor blade or wallpaper scraper. Each slit is definitely around 20 or 25 cm apart.
2. Apply drinking water or wallpaper remover and wait a few minutes for the wallpaper to completely saturate.
3. Repeat the same procedure on another wallpaper strip, then return to the 1st strip and re-wet it from top to bottom with the formulation.
4. Start stripping the wallpaper with a multi-purpose edging knife with a 8.9 cm wide, movable blade. Beginning with a lower horizontal wallet, the blade is definitely placed under its upper advantage and the blade is at an angle of 30 degrees to the horizontal, and the sliding blade scrapes the wetted wallpaper. A wallpaper this is the same width as the squeegee will fall off the blade and roll onto the squeegee as the blade pushes down.
5. Continue to push down before wallpaper can’t be taken off. If the scraped wallpaper tape breaks, re-infiltrate this area and start to scrape another tape.

Steam method
It is not simple to peel from the lime aged wallpaper. You can rent a steam engine, nevertheless, you still need to use a wide-blade putty knife to scrape the majority of the wallpaper.
1. Following the water is warm, press the steam plate on the wall before wallpaper on the edge of the steam plate becomes dark because of moisture. Start with a strip of paper and gradually peel off the wallpaper from top to bottom.
2. After steaming fifty percent of the paper strip, make use of a nail or a utility knife to draw up the part of the top of the wallpaper and tear off the wallpaper. If the wallpaper can’t be removed, it could be scraped off with a wall structure scraper. You might want to steam the same area twice or three times to loosen the adhesive for the longer a few months of the wallpaper.

For waterproof coatings, cleaning the wall paper glue with alcohol will not cause much damage to the wall. Rather, the volatilization of Classic Wallpaper alcoholic beverages can minimize the harm to the wall structure. But one thing to notice is that the concentration of alcohol shouldn’t be too high. In any other case, the volatility is certainly too big, and it is simple to make the white wall turn yellow or dark. This is a very bad phenomenon.

This method uses physical friction. But because salt is normally a white crystal, you don’t need to worry about the unusual color that the friction brings to the wall. In the process of rubbing, you can use white gauze or cloth that can hold salt, pack a small packet of salt, carefully rub, slowly you will see that the glue still left on the wall structure paper is slowly disappearing, and then stuck in On the top of the fabric, you just want to rub and prevent to eliminate the glue from the gauze. The next phase is not to be said.