Rubber powder EPTry
one.Ring cutter
This EPT largely utilised to reduce the sidewall of steel wire tire ,and then to the subsequent phase of segmentation .1st, set the tire on the platform, then rotate the hand wheel , the a few claws will adhere the inner tire firmly ,2nd ,Starting EPT,function system will rotation ,cutting tool according to need to minimize tire gradually action by phase . right up until the tire aspect lower off.
two.Strips cutter
strips chopping EPT can lower cycle EPT to get rid of the wire tire sidewall cut into strips ,and the width of the adjustable section .Two round knives for EPT resources ,challenging and tough , can be utilised repeatedly grinding for no far more than 1200 metal tires.
three.Block cutter
Block cutter is created to reduce automobile, truck and rear tractor tire. range is up to 120cm truck tires. the tire cutter adds fleXiHu (West Lake) Dis.bility to your total tire cutting program by providing you the opportunities of accepting tires up to 120cm into your method ,The unit also allows your technique to cut sixty-70 truck tires per hour or one hundred twenty-a hundred and fifty vehicle tires for every hour.
four.Bead wire separation
Be uEPTzed to separate rubber and metal wire of bead in orEPTto get EPT steel wire .
Attribute:It is simple operation ,effortless to be mounted and maintained high efficiency and clean and many others.
5.Tyre crusher
This EPT is mostly utilized to crush waste tire and rubber .the construction is equipment EPT
six. Selection and transportation method
Entirely-vehicle waste tire recycle line
Usage:
It could be applied to lower all varieties of rubber blocks and strips. It is great for reducing rubber tyre, rail tyre, rubber strips and so on.
Construction amp Theory: :
It primarily consists of the motor, chopping blades, static blades, body, oil cylinder, hydraulic system, control box, and many others.
Its simple theory is: The oil cylinEPTand hydraulic system are driven by a motor. Put the tyre without having wire bead on the stand of the static blades. The tyre is set by locking arms tightly then minimize by the blades driven by oil cylinder. The tyre is cut into a number of blocks, which will be much more effortlessly crushed or shredded for the following approach.
| Sort
Technological parameter |
XKP-400 | XKP-450 | XKP-560 |
| Entrance roll diameter(mm) | 400 | 450 | 560 |
| Rear roll diameter(mm) | 400(Groove roller) | 450(Groove roller) | 510(Groove roller) |
| Operating duration of rolls(mm) | 600 | 650 | 800 |
| Entrance roll surface pace(m/min) | 17.32 | 23.2 | 24.56 |
| Friction ratio | one:1.38 | 1:one.38 | one:1.thirty |
| Max.nip(mm0 | eight | eight | fifteen |
| Motor EPT | 45 | 55 | 75 |
| Overall dimension: duration timesWidth timesHeight(mm) | 3950 times1800 times1780 | 4770 times1846 times1835 | 5064 |
